Temperature Adjustment - Kenmore 911.36655 El Manual Del Propietario

"DOIT YOURSELF"
TEMPERATURE
ADJUSTMENT
You may feel that your new oven cooks
differently than lhe oven it replaced. We
recommend that you use your new oven
a few weeks to become more familiar
with it, following the times given in your
recipes as a guide,
If you think your new oven is too hot
(burning foods) or not hot enough
(foods are undercooked) you can
adjust the temperature yourself_ The
appearance and texture of foods is a
better indicator of oven accuracy than
oven lhermometers, to check the
temperature setting of your new oven.
These thermometers can vary by 20-40
degrees. In addition, the oven door
must be opened to read these
thermometers. Opening the door will
change the temperature of the oven_
To decide how much to change the
temperature, set the oven temperature
25 degrees higher (if foods are
undercooked) or 25 degrees lower (if
foods are burning) than the temperature
in your recipe, then bake. The results of
this "test" should give you an idea of
how much the temperature should be
changed.
1. Press the BAKE pad.
m
Press the UP arrow pad to
set 550 ° and
IMMEDIATELY press
and HOLD the BAKE pad
for 10 seconds until the
clock disappears and the
display shows a two digit
figure.
( This two digit number may vary according
to the original factory setting,)
3. Press the UP arrow to
increase your oven's
temperature up to +35 °
HOTTER
B Press the DOWH arrow
pad to decrease your
oven's temperature down
to -35 ° COOLER,
_ 4.When selection is
your
complete press the
CLOCK pad to return to
the time of day.
Your oven's thermostat will retain this
temperature adjustment until each of
the four steps above are repeated
This adjustment will remain in memory
even after a power failure.
You will not need to do anything else.
Bake as you normally would This
adjustment will not affect broiJ or
clean temperature.
26