Inglesina QUAD PRO Istrucciones De Uso página 25

DETACHING THE HOOD FROM THE STROLLER
points on the backrest of the seat.
CARING FOR THE HOOD LINING
The lining of the hood can be removed for it to be cared for properly.
Remove the elastic eyelets (H5) from both couplings and release the buttons on the hood
H6).
Then remove the white front (H7) and rear black (H8) safety bands from both
H6) and remove the lining completely.
in the relative guides on the inner lining.
making sure the white safety band (H7) remains at the front and the black one (H8) at the
back.
Complete the assembly by coupling the two small elastic eyelets (H5) to both hood
H1-H2) and buttoning up the side snap fasteners.
MUFF (IF AVAILABLE)
Place the muff (R3) making it pass under the handrail.
Button up the central binding (F1), making it pass through the ring (F2).
The muff reverse can also be attached in a suitable position for protecting the child
against cold weather.
The muff can be used on both rear facing and forward facing pushchair seats.
RAIN COVER (IF PRESENT)
To mount rain cover (R4), place it on the hood and button up the snap fastners on
the side (P1).
Then complete the assembly by passing the elastic (P2) under the footrest of the
seat.
CARING FOR THE LINING
It is recommended to remove the lining periodically to provide for its correct maintenance.
Remove the two small lower elastic bands (R12) from the footrest and remove it
from the support.
Remove the elastic band (R13) from both sides of the seat.
Release the buttons on the seat (R14) and on the eyelets (R15).
Remove the back straps from the fabric shoulder straps.
Remove the waist strap from the side loops (R8
tooth of the central buckle pass through the side loop before removing it completely.
Pass the shoulder straps and the crotch strap through the eyelets on the lining and
remove it completely.
WARNING: make sure that the lining has been properly reassembled before use.
H7) and rear black (H8) safety bands
H9),
25