Solo 582 Manual De Funcionamiento página 22

Faults
Rough running,
machine vibrates strongly - blade fasteners loose
Engine will not start
Engine runs roughly
Starter cord snatches back - blade fastener or friction clutch loose
Lawn turns yellow
Low quality cut
Mower collects
cuttings poorly
We expressly decline any warranty in accordance with the Comsumer's Protection Act relating to any
losses caused by this equipment, if these are the result of incorrect repairs or if replacements parts were
not original SOLO spare parts or such parts authorised by SOLO, and/or repairs were carried out by others
than an approved customer service shop or authorised expert. The same conditions apply to
supplementary equipment and accessories.
2 2
Possible cause
- engine bolts or mower chassis fasteners loose
- blade out of balance or faulty
- friction clutch faulty
- has the brake bar been pulled/pressed
against the handle?
- is the throttle control correctly positioned?
- is the Bowden cable/engine brake
in the correct position?
- spark plug or spark plug cap faulty?
- fuel tank empty
- air filter contaminated
- throttle Bowden cable kinked
- spark plug sooty
- blade blunt
- cutting height too low
- engine speed too low
- engine speed to low
- cutting height too low
for tall grass
- blade worn
- grass catcher bag clogged up
Remedy
- retighten screws/bolts
- check blade fasteners
- balance or replace cutting blade
- possibly replace friction washers
(in pairs)
- press/pull the brake bar
- select correct adjustment
- check for correct adjustment
- clean or replace spark plug or cap
- refuel
- clean or replace air filter
- adjust or replace throttle Bowden cable
- clean spark plug
- check blade fasteners
- sharpen the cutting blade
- correct height adjustment
- move throttle control to max.
- move throttle control to max.
- correct height adjustment
- replace the cutting blade
- clean or replace the grass catcher bag