Amann Girrbach ceramill motion 2 Manual Del Usuario página 58

I N S T A L L A T I O N
5.1.2 Ceramill Motion 2 Set-up with Ceramill
Coolstream
E N
Please refer to the separate Ceramill
Motion 2 and Ceramill Coolstream set-up
instructions.
In conjunction with the Ceramill Coolstream sup-
ply unit, the Ceramill Motion 2 is set up either
directly on the Ceramill Coolstream (tower ver-
sion) or on a table above the Ceramill Coolstream
(table version).
Installation of the Ceramill Airstream in the
Ceramill Coolstream
When dry processing with air extraction via the
Ceramill Airstream, the air extraction can be
installed in the Ceramill Coolstream (please refer
to the Ceramill Airstream set-up instructions).
This simplifies the cabling.
Fig. 6
1 Ceramill Coolstream
2 Ceramill Airstream
58
▷ Set the Ceramill Airstream to the operating
mode AUTO.
▷ Place the Ceramill Airstream with the extraction
opening facing toward the rear into the Ceramill
Coolstream.
Malfunction!
▷ Do not plug the control cable of the
Ceramill Airstream into the Ceramill
Motion 2!
▷ Plug the control cable of the Ceramill Airstream
into the Ceramill Coolstream.
▷ Plug the extraction hose of the Ceramill Air-
stream into the Ceramill Motion 2.
1
2