Changing The Blank Holder; Checking The Model Area - Amann Girrbach ceramill motion 2 Manual Del Usuario

Ocultar thumbs Ver también para ceramill motion 2:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

A P P L I C A T I O N A N D O P E R A T I O N
6.2

Changing the Blank Holder

In delivery condition, the Ceramill Motion 2 is
E N
equipped with a 71 blank holder. For processing
varying materials, it may be required to use a dif-
ferent blank holder.
To change the blank holder:
▷ With the door closed, press operation button [A]
for at least three seconds.
The current tool is placed down. The blank
holder [2] moves to the change position.
1
Fig. 20 Five-axis model
Fig. 21 Four-axis model
Legend to Fig. 20 and Fig. 21:
1 Fastening screw for blank holder
2 Blank holder
▷ Loosen fastening screw [1].
▷ Pull off the blank holder toward the right (five-
axis model) resp. toward the bottom (four-axis
model).
70
1
2
▷ Clean the locating bore and surfaces.
▷ Check the pin on the blank holder to be mounted
and clean, if required.
▷ Insert the blank holder with the pin to the stop
in the locating bore.
NOTE:
Inaccurate working results or damage to the
blank-holder fixture possible!
▷ Tighten fastening screw [1] with a torque of
4 Nm.
The supplied torque wrench is set accordingly.
▷ Tighten fastening screw [1] with with the sup-
2
plied torque wrench.
▷ Briefly press operation button [A].
The machine advances to the starting position.
6.3

Checking the Model Area

The model area, on which the work is to be
machined, must fit within the contour of the
enclosed template (also see Match Package). Oth-
erwise, the work cannot be machined in the blank.
The template takes into account the shrinkage of
the zirconium oxide in the final sintering.
Fig. 22 Template for ZI 71 zirconium oxide
▷ For work in wax or plastic, measure out the
model area.

Hide quick links:

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ceramill coolstream

Tabla de contenido