Connecting With Video (Cvbs) Cable - Magnavox MRV640 Manual De Instrucciones

Connecting with Video (CVBS) cable

This cable, usually featuring yellow plugs, is used for transmitting the Composite Video signal
(FBAS, CVBS). In this method of transmission the color signal and the brightness signal are
transmitted on the same cable. Under certain circumstances, this may lead to problems with the
picture, such as 'Moiré' patterns. However, it is one of the most common and likely connections
to a TV.
Have the following cables ready:
an RF coaxial cable (1, supplied), a power cable (2, supplied), a video (CVBS) cable (3, with
yellow ends), and an audio cables (4 with red/white ends).
1
Remove the antenna or Cable TV signal from your TV. Connect
it to the ANTENNA IN jack at the back of the DVD recorder.
2
Connect one end of the supplied RF coaxial cable to the TV
OUT jack at the back of the DVD Recorder and connect the
other end to the antenna input jack on TV.
3
Connect a video (CVBS) cable to the yellow VIDEO (CVBS)
OUT jack at the back of the DVD Recorder and to the Video In
jack (usually yellow) of the TV (usually called Video in or AV in.
See your TV's instruction manual).
4
Connect an audio cable to the red/white L AUDIO R OUT jacks
at the back of the DVD Recorder (under VIDEO (CVBS) ) and
to the corresponding red/white audio input jacks of the TV
(usually called 'Audio in' or 'AV in'. See your TV's instruction
manual).
5
Switch on the TV. Switch the TV to the Video/Audio input
channel. For the channel number, please see your TV's instruction
manual.
6
Connect the
4MAINS at the back of the DVD Recorder and to a power
supply.
The most important features of the DVD Recorder will appear
on the display.
After the initial installation is completed, this function will be
switched off. To switch on this function again, read in the section
'Standby' in the chapter 'User preferences'.
Press STANDBY-ON m on the recorder. 'IS TV ON?' will
7
appear on the display.
Then, read 'Initial installation' in the chapter 'Installing your DVD recorder'.
Connecting the DVD Recorder
supplied power cable to the mains jack
15