the closing handle.
Close the bottom cover again.
Make sure the ash bin is secured in place before
12.2.3 Cleaning the glass
The stove is provided with an exclusive glass
autocleaning system which reduces the upkeep
frequency.
Nevertheless in the long run, according to the
work conditions and the kind of pellet used, it is
necessary to clean the glass manually.
This is done using a damp cloth or moistened
paper passed through the ash (Fig.12.7). Rub until
glass can also be used.
Never clean the glass while the stove is operating
and never use abrasive sponges.
Do not wet the door gasket as this may be
damaged.
12.2.4 Cleaning
This should be performed at least twice a year , at
the start of and half-way through winter , and in any
case whenever necessary (Fig.12.8).
If there are horizontal sections, check for and
remove any accumulated ash and soot before
If not cleaned correctly, the stove may not operate
properly, with problems including:
poor combustion;
blackening of the glass;
blockage of the burn pot by ash and pellets;
accumulated ash and excessive fouling of the
heat exchanger, with a consequent decline in
12.2.5 Cleaning the outside of the stove
The outside of the stove must only be cleaned
using a dry, non-abrasive cloth.
Do not use detergents and never clean when the
stove is hot.
58/144
USE AND & MAINTENANCE
Fig. 12.7
Fig. 12.8
cod. 004771980 - 09/2014 - Palazzetti - PN - Italy