System Messages - Oase ProfiClear Premium Compact Instrucciones De Uso

- EN -
6.8

System messages

The 4-digit system message is displayed as two groups of two digits appearing in succession.
System message Functions that
are still available
Er11
Container cover raised

Er22
Water temperature > 12 °C 
AND the last automatic 
cleaning process was carried

out more than 24 hours ago.


Er33
20 cleaning cycles in 
succession 
56
Possible cause
Manual cleaning Container cover raised
(only nozzles,
Container cover incorrectly fitted
filter drum not
rotating)
Signal box not connected
Manual cleaning Screen elements leaking
Automatic mode
Drum seal leaking
Time-dependent
cleaning
Level detection device stuck or defective
Level detection device set incorrectly
Manual cleaning 24 hour check mode is active and time-dependent cleaning
Automatic mode is deactivated.
Manual cleaning Level detection device stuck or defective
Time-dependent
cleaning
Screen elements heavily soiled
Rinsing pump not operating
Rinsing nozzle clogged
Filter drum not rotating
Level detection device set too low
Water level in the system too high:
 Outlet pipes soiled
 Outlet opening too small
Excessive flow quantity (pump capacity too high)

 The pond water is very dirty and the filter pump is
conveying an excessive amount of dirt.
 A large amount of dirt has entered the filter system, water
is flowing over (instead of through) the foam filters.
Remedy
Refit the container cover
Turn the container cover around so that the magnets in
the container cover are located over the signal box
Connect the signal box to the control system
Check screen elements, replace if necessary
Check the drum seal
Clean the level detection device to ensure that the
mechanics operate freely, replace if necessary
Adjust the level detection device (→ Adjusting the level
detection device)
Time-dependent cleaning is automatically activated by
floats after check mode.
Clean the level detection device to ensure that the
mechanics operate freely, replace if necessary
Clean/descale the screen elements (→ Removing/fitting a
screen element)
Clean the bottom of the container, clean the rinsing

pump (→ Cleaning the rinsing pump)
 Check the pump connection
Clean the rinsing nozzle
Check the motor connection

 Check the rotating movement of the filter drum.
Tip: Mark the filter drum and check on the basis of the
markings if the drum rotates.
Adjust the level detection device (→ Adjusting the level
detection device)
 Clean outlet pipes
 Enlarge outlet opening
Reduce flow quantity (adjust pump capacity)

 Thoroughly clean the pond.
Install the pump in an elevated position.

 Clean foam filters
Resetting the system
message
Automatic when the
container cover is
replaced
On|Off
 Press key for
5 s
Automatic as soon as

the level detection
device is triggered
On|Off
Press key for 5 s