Assignment Of Configuration Fault 107 - baltur BT 320 Guía Rápida

3 ASSIGNMENT OF
CONFIGURATION FAULT 107
D1
1
Too many channels in configuration parameter 804.
2
No channel at all configured.
3
Permanent ignition burner configured (parameter 302,
303), but no ignition flame monitoring device present
(parameter 800).
6
Prepurge suppression via external signal not implemented.
7
Fuel change via Off and an unlimited post ventilation
configured.
8
Prepurge time is smaller than minimal prepurge time.
9
For stages oil mode.
13
Australian flame monitoring configured, but no ignition
flame monitoring device.
18
Standby operation at BT300 not allowed.
19
Invalid fuel change selected.
20
BT300 only with separate ignition point.
21
"Ignition With Fan", only useful with pure oil devices.
22
Staged operation only useful with pure oil devices.
23
3-staged operation only works without ignition burner.
24
Permanent operation not allowed (Featureflag).
25
Fuel change not allowed (Featureflag).
26
Too many channels (Featureflag).
27
Staged oil burners need an air channel.
28
There is an invalid function configured for a channel
(Parameter 400-404).
30
Multiple terminals defined for one signal, Terminal
configuration invalid.
31
No output terminal for fan or transformer available.
32
Necessary outputs for operation with oil not available (Oil
pump or oil valve).
33
Necessary outputs for operation with gas not available
(gas valve).
34
An output terminal is needed for the ignition valve, but is
not available in the actual terminal configuration.
40
No input terminal for the air pressure monitor available.
41
No input terminal for the oil safety chain available (oil
pressure min will not be monitored directly, because it can
be included in the safety chain).
42
No input terminal for the gas safety chain or minimum gas
pressure available.
43
The feedback line for the fuel selection is not mapped,
but is required.
Description
0006081511_201311
40 / 50