Operating Limits; Typical System - King gates DYNAMOS XL1800 Instrucciones Y Advertencias Para La Instalación Y El Uso

1
3. Installation
The installation of Dynamos must be carried out by qualified per-
sonnel in compliance with current legislation, standards and regula-
tions, and the directions provided in this manual.
3.1 -

Operating limits

The effective suitability of Dynamos to automate a particular sliding
2
1
2
1 Key switch
2 Photocells
3 Open stop bracket
4
3
4 Rack
5 Flasher with integral antenna
6 Dynamos
400 mm
gate depends on the friction as well as other correlated factors, such
as ice, which may interfere with the movement of the gate.
For an effective control it is absolutely vital to measure the force nec-
essary to move the gate throughout its entire run and ensure that this
is less than half of the "nominal torque" indicated in chapter 5 - Tech-
nical characteristics; a 50% margin on the force is recommended,
as unfavourable climatic conditions may cause an increase in the
friction.
3.2 -

Typical system

Fig. 2 shows a typical sliding gate automated by Dynamos.
5
2
6
4
8
253 mm
7
7 Closed stop bracket
8 Transmitter