Maintenance And Inspection; Safety Measures; Maintenance And Inspection Table - CEMO 10507 Manual De Instrucciones

6. Maintenance and inspection

6.1 Safety measures

i
Important!
The operator must provide any
protective clothing that may be required.

6.2 Maintenance and inspection table

Interval
As required
Monthly
Monthly
Annually
Annually, or more
frequently if needed
Regular maintenance of the hand pump is
not necessary.
The filter is located between the hose sleeve
and ball valve.
To clean the filter, close the ball valve and
unscrew and remove the hose sleeve.
m
m Filling pipe with KITO
elements for filling (13.1) and venting (13.2)
Remove anti-twist mechanism
Remove filling pipe
m
arrester elements 13.1 and 13.2 with com-
pressed air. Do not, under any circumstances,
Assembly
Outside of filling station
Container
Piping system
Filter
KITO flame arrester
®
elements
13.1
13.2
flame arrester
®
.
l
, blow out KITO flame
®
Maintenance may only be carried out by
instructed personnel.
In areas where there is an explosion risk,
work on the openings must only be carried out
with the approved (low-sparking) tool.
Action
Remove any dirt
Visual check for damage
Check hoses for cracks and porosity,
check fittings for leaks (replace defective parts)
Clean
Blow out the elements with compressed air.
Hose sleeve
Seal
Filter
Ball valve
remove the flame arrester. Check for damage
caused by corrosion, mechanical loads or
tarnishing, and for loose and slipping strip coils
as a result of flashbacks.
- If there is visible dirt on the elements 13.1
and 13.2 which cannot be blown out, or if they
are damaged, the whole filling pipe
be replaced as otherwise the filling speed will
be reduced, in which case the flame arrester
function is no longer guaranteed.
If a flashback has occurred, the whole fuel
trolley must be checked and the KITO
in the filling pipe replaced.
GB
must
m
elements
®
19