Unpacking And Set Up Summary; Caster/Accessory Holder Assembly; Filters Assembly - Stanley SL18129 Manual Del Propietário

UNPACKING & SET-UP SUMMARY
1. Pull lid latches in an outward motion, remove power head and some accessories that may have been shipped in the tank.
2. Attach casters following the instructions in this manual.
3. Before replacing power head, refer to Filters Assembly and Power Head Assembly and Operation in this manual to ensure
you have the proper filters installed for your cleaning operation.
4. Replace power head, and apply pressure with thumb to each latch until it snaps tightly in place. Make sure all lid latches are
clamped securely.
5. Insert the flexible hose end into inlet of tank.
6. Attach the extension wands to the accessory end of the hose. Twist slightly to tighten the connection.
7. Attach one of the cleaning accessories (depending on your cleaning requirements) on the extension wands.
Twist slightly to tighten the connection.
8. Plug the cord into the wall outlet. Your cleaner is ready for use
CASTER / ACCESSORY HOLDER ASSEMBLY
Not standard with all models
1. Invert dust tank, Insert caster (part H) into foot by placing stem of caster into the holes provided. Apply pressure and
twisting motion until casters snap into place. （Picture 1） Caster will swivel easily when positioning is correct. Rotate
dust tank assembly upright.
2. Place accessories holder (part L), with curved surface against tank, on rear caster dolly.（Picture 2）
3. Using a long screwdriver, install screws (part L) into matching holes on both side of accessory holder. Tighten screws
until just snug. Do not over tighten as this may tend to deform the dollies.

FILTERS ASSEMBLY

CARTRIDGE FILTER ASSEMBLY
1. With the power head in an upside down position, slide the filter (part J) down over the lid cage. Push until the filter
seals against the cover.（Picture 3）
2. Hold the power head with one hand, turn the handle on the filter retainer clockwise to tighten, locking the filter into
place.（Picture 4）
IMPORTANT: Do not over tighten as this may deform or crack the filter cage or filter.
3. To remove the filter for cleaning, again hold the tank cover and turn the filter retainer counter-clock-wise to loosen and
remove it.（Picture 5）
4. Slide the cartridge filter off the lid cage. （Picture 6）
DISPOSABLE FILTER BAG ASSEMBLY
5. Slide collar of disposable filter bag (part K) attached into deflector guide and turn it in counter clockwise to lock the bag in place.
6. To remove the disposable filter bag, turn the bag in clockwise and slide out of the deflector guide. (Picture 7)
-4-