Before You Begin; Avant De Commencer - Kohler K-8359 Guía De Instalación Y Cuidado

Grifería de montaje en bañera/cubierta
Ocultar thumbs Ver también para K-8359:
Tabla de contenido

Publicidad

Tools/Outils/Herramientas
Drill with 1-1/4" and 7/8" Hole Bits
Perceuse avec nèches de 1-1/4" et 7/8"
Taladro con brocas de corona de 1-1/4" y 7/8"
Level
Niveau à bulle
Nivel

Before You Begin

Please read all instructions before you begin.
Observe all local plumbing and building codes.
Shut off the water supply.
The dimensions given assume the spout and bath are mounted on the same
surface. Adjust the dimensions accordingly if the spout and bath are mounted on
different surfaces.
If this product is installed with an overflowing bath, the outer rim of the bath
should slightly overlap the 2x4 framing.
Installer supplied copper tubing must be 5/8" OD (1/2" Nominal).
The plaster guard diameter is 7/8" (2.2 cm) from the spout.
Leave the protective sleeve on the spout supply tube until spout installation. This
is an O-ring sealing surface which may be damaged when unprotected.
The finished wall to which the spout is installed should add less than 1-1/2" (3.8
cm) of thickness to the outside of the rough-in wall.
For installation on baths other than an overflowing bath, a wider deck may be
required. Carefully review this document and any appropriate rough-in sheets.
Design the bath enclosure accordingly.
Kohler Co. reserves the right to make revisions in the design of faucets without
notice, as specified in the Price Book.

Avant de commencer

Veuillez lire toutes les instructions avant de commencer.
Respecter tous les codes de plomberie et de bâtiment locaux.
Couper l'alimentation d'eau.
Les dimensions fournies partent du principe que le bec et la baignoire sont montés
sur la même surface. Ajuster les dimensions sachant que le bec et la baignoire sont
montés sur des surfaces différentes.
Si le produit est installé avec une baignoire à déversement, le rebord extérieur de
la baignoire devra légèrement chevaucher le cadrage de 2x4.
La tuyautrerie en cuivre fourni par l'installateur doit être de Ø Ext 5/8" (1/2"
nominal).
Kohler Co.
Pencil
Tape Measure
Crayon à papier
Mètre ruban
Lápiz
Cinta para medir
Masking Tape
Plumbers Putty
Ruban cache
Mastic de plomberie
Cinta adhesiva
Masilla de plomería
3
1089448-2-A

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

K-8361K-8362

Tabla de contenido