9
Use the left arrow key to back out to the main
screen
Access Control is enabled.
Walk Up Operation
Logging In
General Users
1
Enter your assigned PIN using the ten-key
pad on the control panel.
2
Press <OK>.
The main screen appears.
Administrator
1
Enter "000000" using the ten-key pad on the
control panel, then press <OK>
• The PIN of the administrator is "000000".
You cannot change this value.
2
When the Admin Password screen appears,
enter the administrator password: use the
arrow keys to select the digits of the
password, pressing <OK> after highlighting
each digit.
3
Use the arrow keys to select [Enter] on the
display, then press <OK>.
The main screen appears.
Logging Out
When you have finished using the machine, be
sure to log out.
1
Press the left arrow key until the main screen
appears.
2
Press <RESET/LOGOUT> on the control
panel.
The screen returns to the PIN entry prompt.
Note
After a certain period of time, the machine
automatically logs out users.
Setting Up Operation From a
Computer with Authentication
by PIN
First, make sure the appropriate machine
driver(s) have been installed on the computer
using the DVD.
Second, install Job Accounting (client) software
on the computer. To do this, place the DVD
supplied with the machine in the computer drive
and follow the screen prompts to download the
Job Accounting software from the internet.
Note
The authentication type specified on the
computer overrides the one specified on the
machine.
Setting Up Windows Computers for
Printing
Note
This procedure uses MC561 and Windows 7 as an
example. The procedures and menus may differ
depending on the operating system you use.
1
Click [Start] > [All Programs] > [Okidata] >
[Print Job Accounting Client] > [Change Job
Accounting Mode].
42 - English