Bose SoundTouch 130 Guia Del Usuario página 35

Problem
Remote control
is inconsistent or
does not work
System does not
sync with the
correct source /
selects the incor-
rect source after
delay (CEC)
CEC
inconsistent or
does not work
Poor or distorted
sound
What to do
+ –
• Match the and
ings inside the compartment (see page 19).
• Replace the battery (see page 19).
• Press the volume button on the remote control and see if the correct
source button flashes.
• Remove the protective film from the console.
• Reset your source button (see page 38).
• If using CEC:
- Point the remote control at the console.
- Use the Alternate On setting (see page 32).
- Disable CEC on your system (see page 32) and program the
remote to control your source (see page 25).
• If you have programmed the remote to control your source:
- Point the remote control at the appropriate source.
- Ensure you have entered the correct code for your source's brand.
- Program the remote with another code (see page 25).
• Use the Alternate On setting (see page 32).
• Disable CEC on your source (refer to your source owner's guide for
more information).
• Disable CEC on your system (see page 32) and program the
remote to control your source (see page 25).
• Use the Alternate On setting (see page 32).
• Disable CEC on your source (refer to your source owner's guide for
more information).
• Disable CEC on your system (see page 32) and program the
remote to control your source (see page 25).
• Remove all protective films from the system.
• Secure all cable connections on the soundbar, TV and connected
sources.
• If you see the error message Cannot find Acoustimass:
- Plug in the Acoustimass
- Pair the Acoustimass module with the console (see page 37).
• If using the analog or
source.
• Factory reset the system (see page 38) and run the ADAPTiQ
audio calibration (see page 21).
Care and Maintenance
symbols on the batteries with the
module.
®
connector, decrease the volume on your
+ –
and mark-
®
English - 35