ECOFOREST ECO GLASS 70 Manual De Instalación, Uso Y Mantenimiento página 34

8.7. Convector assembly.
To clean the dust that may accumulate in the convector assembly, or to conduct any repairs on it, follow the
steps outlined below. Unplug the power cord from the mains. Remove the 8 screws that secure the assembly
to the front of the stove. Gently pull the assembly, taking care that the power cord does not snag. After
finishing the cleaning or repair, replace the assembly and secure with the screws.

Assembly fixing screws.

Convector assembly.
9. PROBLEMS AND RECOMENDATIONS.
PROBLEM
 SMOKE DURING
LIGHTING
OPERATION.
 GLASS GETS DIRTY.
 FIRE GOES OUT.
 VERY HOT FIRE.
 CONVECTOR DOES NOT
WORK.
 DOES NOT PROVIDE
ENOUGH HEAT.
POSSIBLE CAUSES
 Weak draught, because the stove was
not lit correctly.
OR
 Wet or green wood.
 Flue (chimney) obstructed.
 Insufficient draught.
 Wet or green wood.
 Logs too large.
 Combustion air regulator closed.
 Combustion air damper open.
 Unsuitable fuel.
 Power failure.
 Convector fault.
 Thermostat fault.
 Not enough wood.
 Unsuitable fuel.
 Too much draught.
 Poorly insulated location.
 Follow the steps in section 6.2.
 Use dry wood.
 Check the condition of the flue
(chimney). Clean, if necessary.
 Increase the height of the chimney, to
achieve optimal low pressure for stove
operation.
 Use dry wood.
 Light as explained in point 6.
 Open the combustion air damper.
Once the wood has caught enough, set
the damper in the desired position.
 Close the combustion air damper.
 Use the fuel recommended in the user
manual.
 Check the mains connection to the
house.
 Contact the supplier of the stove.
 Use the recommended amount of
firewood.
 Use the fuel recommended in the user
manual.
 Regulate the combustion air. Reread
section 4.3. and contact the stove
installer, if necessary.
 Check the rated power is suitable for
the characteristics of the installation.
33
Drawing 28
SOLUTIONS