Battery Charging (See Figure A) - Bosch PSR Select Manual Original

OBJ_DOKU-28872-003.fm Page 32 Tuesday, August 19, 2014 5:11 PM
32 | English
Technical file (2006/42/EC) at:
Robert Bosch GmbH, PT/ETM9,
70764 Leinfelden-Echterdingen
GERMANY
Henk Becker
Executive Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
70764 Leinfelden-Echterdingen, GERMANY
20.08.2014
Assembly
 Before any work on the machine (e. g., maintenance, tool change,
etc.) as well as during transport and storage, set the rotational direc-
tion switch to the centre position. Unintentional actuation of the On/Off
switch can lead to injuries.

Battery Charging (see figure A)

 Do not use other battery chargers. The supplied battery charger is de-
signed for the Lithium-Ion battery in your machine.
 Observe the mains voltage! The voltage of the power supply must corre-
spond with the data given on the nameplate of the battery charger. Bat-
tery chargers marked with 230 V can also be operated with 220 V.
Note: The battery supplied is partially charged. To ensure full capacity of the
battery, completely charge the battery in the battery charger before using
your power tool for the first time.
The lithium-ion battery can be charged at any time without reducing its ser-
vice life. Interrupting the charging procedure does not damage the battery.
The lithium-ion battery is protected against deep discharging by the "Elec-
tronic Cell Protection (ECP)". When the battery is empty, the machine is
switched off by means of a protective circuit: The inserted tool no longer ro-
tates.
1 609 92A 0V2 | (19.8.14)
Helmut Heinzelmann
Head of Product Certification
PT/ETM9
Bosch Power Tools