Safety Warnings; Field Of Application - EMAK BT 2100E Manual De Istrucciones

Congratulations on purchasing an EMAK bioshredder.
Th is machine guarantees optimum long-term functionality,
provided that you observe the following warnings.

SAFETY WARNINGS

WARNING - Before each use, check the safety
devices located on the machine.
1. In addition to the instructions of this manual, all
generally applicable safety and accident prevention
standards must be observed.
2. Th e symbols, warnings and safety descriptions provide
important instructions for safe operation: pay attention
to them in order to ensure your safety.
3. Th e machine must not be used by persons under the age
of 18.
4. Th e operator is responsible for the safety of bystanders
within the work area.
5. Wear close-fi tting clothes, ear protection, gloves,
safety shoes and protective eyewear (and a safety visor,
whenever possible).
6. It is prohibited to remain in the hazard zone, especially
in the vicinity of the discharge port.
7. Th e machine must only be positioned and used on stable
surfaces free from obstacles (danger of tipping).
8. To favour the loading of short material, use auxiliary
equipment in the form of circular pieces of wood of
suffi cient length.
9. Before opening the stack or moving away from the
machine, switch off the motor and disconnect the plug.
WARNING - Th e machine may only be operated in
accordance with the above instructions, using the
supplied safety devices.

FIELD OF APPLICATION

Th e machine is designed to crush garden waste including
tree and bush cuttings, dead fl owers etc. Th e maximum
diameter of branch which the machine can process is 40
mm. Th anks to the shredding process, the chopped waste
material transforms into compost much more quickly than
it would in its natural state.
CAUTION - If its consistency is not too fi ne, the
waste material favours the essential supply of
oxygen.
SAFETY WARNINGS AND SYMBOLS (Fig.1)
1. Th is symbol indicates Warning and Caution.
2. Carefully read the instruction manual before using the
machine.
3. Wear ear protection when using this unit.
4. Wear eye protection when using this unit.
BIOSHREDDER COMPONENTS (Fig.2)
1. Transport handles
2. Infeed opening
3. Stack
4. Blade inspection access knob
5. Switch
6. Socket
7. Electric motor
8. Transport wheels
9. Support legs
10. Discharge port
Fig. 2
MACHINE STRUCTURE
Th e machine is supplied fully assembled. Before starting
the machine, it is recommended to check the blade-
holder disc for the presence of foreign matter which may
have accumulated during transport or storage, and which
can cause the machine to jam during start-up. Aft er
approximately the fi rst 1 hour of operation, ensure that all
of the blade screws and the screw securing the blade-holder
disc are fully tightened.
START-UP
Before inserting the plug into the socket, check that the
mains voltage corresponds to the data on the ID plate. Th e
voltage must be 230 V. Th e supply cable must be protected
with a 16 A slow-blow fuse.
Aft er the plug is inserted, the machine is ready for use and
may be switched on and off using the switch located on the
control panel.
Th e control panel incorporates a circuit breaker which
disables the power supply in the event of overload or
blockage.
If the power supply is disabled due to overload or blockage,
switch the machine off and wait approximately 30 seconds
before switching it back on. Th is can be done by pressing
the switch once more.
Fig. 1
If the machine becomes clogged, fl ick the switch to "0" and
S.P.A.
GB
5