Safety Warnings; Field Of Application - EMAK BT 2400E Manual De Instrucciones

Congratulations on purchasing an EMAK bioshredder.
This machine guarantees optimum long-term functionality,
provided that you observe the following warnings.

SAFETY WARNINGS

WARNING - Before each use, check the safety devices
located on the machine.
1. In addition to the instructions of this manual, all generally
applicable safety and accident prevention standards must
be observed.
2. The symbols, warnings and safety descriptions provide
important instructions for safe operation: pay attention
to them in order to ensure your safety.
3. The machine must not be used by persons under the age
of 18.
4. The operator is responsible for the safety of bystanders
within the work area.
5. Wear close-fitting clothes, ear protection, gloves,
safety shoes and protective eyewear (and a safety visor,
whenever possible).
6. It is prohibited to remain in the hazard zone, especially
in the vicinity of the discharge port.
7. The machine must only be positioned and used on stable
surfaces free from obstacles (danger of tipping).
8. To favour the loading of short material, use auxiliary
equipment in the form of circular pieces of wood of
sufficient length.
9. Before opening the stack or moving away from the
machine, switch off the motor and disconnect the plug..
WARNING - The machine may only be operated in
www.oleomac.hu
accordance with the above instructions, using the
supplied safety devices.

FIELD OF APPLICATION

The machine is designed to crush garden waste including
tree and bush cuttings, dead flowers etc. For branches
thicker than 20 mm in diameter, use the side infeed opening.
The maximum diameter of branch which the machine can
process is 40 mm. Thanks to the shredding process, the
chopped waste material decomposes into compost much
more quickly than it would in its natural state.
CAUTION - If its consistency is not too fine, the waste
material favours the essential supply of oxygen.
SAFETY WARNINGS AND SYMBOLS (Fig.1)
1. This symbol indicates Warning and Caution.
2. Carefully read the instruction manual before using the
machine.
3. Wear ear protection when using this unit.
4. Wear eye protection when using this unit.
BIOSHREDDER COMPONENTS (Fig.2)
1. Transport handles
2. Infeed opening
3. Knife inspection access lever
4. Stack
5. Cutting adjustment knob
6. Side infeed opening
7. Switch
8. Socket
9. Electric motor
10. Transport wheels
11. Support legs
12. Discharge port
Fig. 2
MACHINE STRUCTURE
The machine is supplied fully assembled. Before starting the
machine, it is recommended to check the blade-holder disc for
the presence of foreign matter which may have accumulated
during transport or storage, and which can cause the machine
to jam during start-up. After approximately the first 1 hour
of operation, ensure that all of the blade screws and the screw
securing the blade-holder disc are fully tightened.
START-UP
Before inserting the plug into the socket, check that the
mains voltage corresponds to the data on the ID plate. The
voltage must be 230 V. The supply cable must be protected
with a 16 A slow-blow fuse.
After the plug is inserted, the machine is ready for use and
may be switched on and off using the switch located on the
control panel.
The electric motor is protected by a circuit breaker which
disables the power supply in the event of overload or
blockage. If the power supply is disabled due to overload or
blockage, wait approximately 5 minutes before switching the
machine back on. The machine can be switched on as before
by pressing the green push-button.
If the machine is clogged, switch it off and disconnect the
Fig. 1
plug before attempting to unblock it. Activate the hopper
S.P.A.
GB
5