Desa Remington 104316-04 Manual Para El Usuario página 23

TROUBLESHOOTING
Note: For additional help, visit DESA Specialty
Products 'TM technical service web site at
www.desatech.com.
A'i
all WARNING: Unplug chain saw from
powersoume beforeservicing. Severeinjury
or death could occur from electrical shock
or body contact with moving chain.
OBSERVED FAULT
Saw runs, but does not cut
POSSIBLE CAUSE REMEDY
Chain assembled backwards on See Assm_bly, page 16
guide bar
Saw does not cut mlless heavily Chain is dull See Shawening Saw Chain, pages
forced. Cutting produces only saw- 20 and 21
dust with few large chips
Saw fulls slow. Saw stalls easily Low power supply voltage Extension cord wire size too small.
See Exmnsion CoMs, page 17
Motorofsaw does not full when you 1. Switch lockout not pressed in to 1. Press in switch lockout before
squeeze trigger release trigger squeezing trigger
2. Extension cord connections loose 2. Check cord connections
3. Open line fuse or circuit breaker 3. Check line fuse or circuit breaker
4. Worn out motor brushes 4. See authorized service center
5. Open wiring circuit on saw 5. See authorized service center
Motor of saw rmls, but chain does Gear train failure See authorized service center
not move
Chain does not get oil 1. Clogged oil slot in guide bar 1. Remove guide bar and clean oil
slot
2. Oil is too thick 2. Use correct weight of oil. See
Filling Oi! Tank, page 17
Chain comes off guide bar 1. Chain is loose 1. Tighten chain. SeeSaw Chain T_,n-
sion Ac!jusm*em. pages 16 and 17
2. Guide bar and chain not as- 2. See Assembly, page 16
sembled right
Saw smokes Saw damaged. Do not use saw See authorized service center
Saw leaks oil Oil cap is not secure Tighten oil cap. Noto:Empty oil tank
when not in use
108539 23 www.desatech.com