Tabla de contenido
Publicidad
BREAK-IN PERIOD
The WP6100 roller is ready for normal operation. However, extra care during the first 50
hours of operation will result in more satisfactory, long-term machine performance and cost
of ownership. Do not exceed 50 hours of operation before conducting the break-in first
service. ee First ervice 50 Hours in the Maintenance ection.
Run engine at full throttle.
Run engine under load. DO NOT overload the engine.
Idle engine 3 minutes before stopping.
DO NOT idle engine for long periods.
Check engine oil level daily.
BEFORE TARTING
Review the following information. pecific information regarding these items can be found
in the Technical Data ection or located by the Table of Contents.
Fuel is highly flammable, handle with care. Do not refuel the engine while smoking or when
near an open flame or sparks. Always stop engine before refueling. Clean up spilled fuel
before starting. Avoid fires by keeping engine clean of accumulated grease and debris.
Diesel fuel stored in galvanized containers reacts chemically with the zinc coating on the
container. The chemical reaction creates powdery flakes of zinc sulfide. If water is present in
the fuel, a zinc hydroxide gel will form.
Do not run unit in an enclosed, unventilated area. Avoid prolonged breathing of exhaust
gases.
PRE- TART CHECKLI T
Check engine oil level.
Check engine air filter.
Check engine fuel level. Note: Always use clean diesel fuel to prevent damage to the
fuel injection components.
Check hydraulic fluid level.
Check hardware for looseness. If loose, tighten according to torque chart.
Check hoses for looseness or leaking.
E- top Button - check that button is not damaged and that it moves properly.
Check radiator coolant.
Check water level.
Operation
WolfPac
6100
TM
27
Publicidad
Tabla de contenido
