Tabla de contenido
Publicidad
should read zero resistance.
Adjustments must be made at transmission.
Disconnect ohmmeter and reconnect interlock wires and battery cables.
CONTROL
Check forward/reverse and throttle every day for smooth operation. Lightly oil cables and
levers every 200 hours.
Replace control cables if any of the following conditions are present, otherwise personal
injury or damage to machine could result. These conditions indicate a present or pending
performance problem.
A gradual or sudden increase or decrease in the friction (no-load)
A gradual or sudden increase or decrease in the usable stroke
Moisture inside the cable and/or frozen cable
Looseness in the forward/reverse lever or cable
Excessive loss of motion in the forward/reverse lever or cable
To avoid risk of injury, do not adjust the control cable with the power on or the engine
THROTTLE LEVER
Throttle should operate smoothly and hold engine at full R M. Engine speed is made by
depressing the button and pulling out for full speed and pushing in for idle speed. Fine
adjustment is made by rotating the knob. Throttle speed may be locked or unlocked by
turning the locking knob clockwise to lock, counter-clockwise to unlock.
WATER TANK
The water tank is polyethylene to prevent corrosion. If the water tank is subject to freezing
temperatures, all the water lines and the water tank must be drained by drawing through
sprinkler tubes or through the flush and
drain plug which is accessed by removing
the cover at the rear of the machine.
WATER TRAINER
Clean every 500 hours. Regular
maintenance of the water strainer will
prevent sprinklers from becoming plugged
with debris. The water strainer is attached
to the water tank located in the rear of the
machine. To clean, remove sediment bowl
WARNING
running.
Maintenance
Water strainer
WolfPac
6100
TM
53
Publicidad
Tabla de contenido
