Tabla de contenido
Publicidad
Then st rt DEAD VEHICLE. Remove c bles in reverse order 4, 3, 2, 1.
Maintenance
CHARGE Y TEM
Ch rge system should be checked every month. With the engine running t full speed,
volt ge should be 13 – 14 volts. If the ch rge system f ils, check the fuse t the control
pl te.
FU E - CONTROL
The electric l system is protected by fuse loc ted t the control pl te. If the electric l
system f ils, check the fuse. If the fuse f ils frequently, it usu lly indic tes short circuit or
n overlo d in the electric l system. Refer to wiring di gr m nd inspect wires.
NOTI E:
Electric l system is not designed for field dd-on electric l options, do not modify
the electric l system. Cont ct your
uthorized de ler.
FU E - REPLACEMENT
Turn the engine switch OFF nd remove
the key before checking or repl cing
fuses to prevent ccident l short-
circuiting.
To repl ce fuse pull the old fuse out of
the fuse holder with your finger. Push
new fuse into the fuse holder.
NOTI E:
Never use fuse with
Fuses
different r ting from th t specified. Serious d m ge to the electric l system or fire m y
result.
IGNITION Y TEM
The Kubot Engine is equipped with n electronic ignition.
When cle ning m chine, c ution should be used round electric l components. Direct w ter
spr y is not good. (Regul tor should be covered or protected if direct spr ying will h ppen).
Excessive w ter pressure m y lso loosen wire connections or st rt termin ls corroding. After
cle ning, ll termin ls should be dried if wet nd connections checked for proper se ting.
ENGINE MOUNTING
Check weekly-tighten ll mounting h rdw re for proper torque, refer to illustr tions in P rts
M nu l for proper torque.
HARDWARE
Inspect ll h rdw re for tightness. Refer to illustr tions in P rts M nu l for proper torque.
LOCTITE
Loctite 262 thre dlocker is required to prevent h rdw re from loosening. Refer to exploded
WolfPac
6100
TM
57
Publicidad
Tabla de contenido
