Operation
WolfPac
6100
TM
34
WATER TANK/ PRINKLER
Check the water level when the roller is parked on level ground and the engine is off. he
water cap is located on top of the water tank (fig. 7). Fill the tank with clean water. he
water tank holds 43 US gallons. Dirty water will clog the sprinkler bars. he roller is
equipped with front and rear sprinklers. If the water tank is subject to freezing
temperatures, all the water lines and the water tank must be drained by draining through
sprinkler tubes.
CRAPER
Scrapers, located on the front and rear of both drums (fig. 7), must make uniform contact
across entire width of drum to ensure even application of water from the sprinkler system.
Also, scrapers prevent dirt and asphalt from collecting.
ECCENTRIC
When vibratory compaction is necessary, engage eccentrics by pushing the vibe button. For
best performance, run engine at full RPM. he eccentrics should be turned off whenever the
roller is stopped, or stopped to change direction. Do not run the eccentric on any non-
yielding surface, such as concrete or aged asphalt.
BEACON (OPTION)
he beacon is located on top of ROPS. he beacon is a self-contained unit, operated by a
rocker switch.
High voltages exist in electronic beacon lights. Before attempting service on any
beacon light, be sure to disconnect the power for at least five minutes to allow the
capacitor to discharge. Failure to heed this warning may result in severe electrical
shock and/or personal injury or equipment damage.
LIGHT (OPTION)
he lights are located both front and rear and are operated by a toggle switch.
WARNING