Tabla de contenido
Publicidad
6. Engine Throttle Lever
7.
Throttle Cable
8. Swivel Washer
9. Swivel Screw
THROTTLE WIVEL
Throttle swivel (5) to be assembled to throttle lever as shown. The throttle cable (3) and jam
nuts are centered around mounting plate to provide full speed (R M) adjustments. If
required, loosen jam nuts (4), center throttle cable, and reposition the throttle swivel.
Adjust Engine dle Speed
1. Check engine idle speed with photo tachometer ( /N 48493) or strobe light.
2. Loosen jam nut on idle stop screw.
3.
Adjust idle stop screw out to increase idle speed or in to decrease idle speed.
4. Confirm with photo tachometer or strobe light and tighten jam nut.
Adjust Engine Full Speed
1. Check engine full speed with photo tachometer or strobe light.
2. Loosen jam nuts on throttle cable connection.
3. Tighten left nut to increase full speed or right nut to decrease full speed.
4. Confirm with photo tachometer or strobe light and tighten jam nut.
Maintenance
WolfPac
6100
TM
47
Publicidad
Tabla de contenido
