Angelcare AC117 El Manual Del Propietario página 14

TO TEST THE SENSOR PAD
MOVEMENT FUNCTION NEED TO BE ACTIVATED:
1
MOVEMENT ALARM
• If NO movement is detected after 15 seconds you will hear
a single 'TIC' pre-alarm sound from the Nursery Unit.
• If after a further 5 seconds there is still NO movement
detected both the Parent Unit and Nursery Unit speakers
will emit loud continuous beeps - this is the Movement Alarm.
• Nursery Unit will flash red light.
• Sensor Pad Icon and sound level bar on Parent Unit will flash.
IF THE ALARM DOES NOT SOUND
• Avoid contact with crib while Sensor Pad is in operation.
• Place crib near a supporting wall.
• Adjust Sensor Pad sensitivity level.
• Turn OFF crib mobile, fans, loud music or anything else that may cause vibration.
TO STOP THE ALARM
14
2
OR
Place your hand
back on the
mattress.
Press PAUSE button
on the Nursery Unit
1) Move your hand lightly on the mattress.
NOTE:
The Parent Unit will emit a
''TIC'' sound (when activated) and
will flashes every 5 seconds.
2) Remove your hand from the mattress.
After 15 seconds you will hear a
'TIC' pre-alarm sound, and 5 seconds
later the Movement Alarm will trigger.
3) Repeat by moving your hand lightly
in all four corners of the mattress.
OR
Press any
button on the
Parent Unit