Electrical Characteristics Of The Control Unit; Technical Characteristics Of The Detection Device; Dimensions Of The Smart Remote Control Box; Transport - SFA SANIFOS 110 Manual De Instalación

UK
Submersion of the control device.
Risk of death by electric shock
Only use the control device in rooms safe from floods.
The SANIFOS
Key
1 Current disconnector
2 Access the menu
3 Returns
4 Menu navigation
5 Activation/deactivation of the pumps
6 Pump operation indicator light
7 Forced operation of pumps

6.1 Electrical characteristics of the control unit

Parameter
Nominal supply voltage
Network frequency
Protection class
Nominal current per engine
- SANIFOS 110 and 250
®
- SANIFOS 500 single phase
®

6.2 Technical characteristics of the detection device

Analog level sensor:
• Signal 0 - 5 V
• Input voltage 0 - 5 V

6.3 Dimensions of the SMART remote control box

6.4 Transport

For all transportation, the control panel must be switched off.
Environmental transport conditions
Environmental conditions
Relative humidity
Ambient temperature

6.5 Connecting the control unit

On the SANIFOS 500, the motor and float cables must be connected to the SMART control box.
®
Preparation of the conductive wires
Conductor
Disassembly length y (mm)
Stripping length x (mm)
130
500 pumping station comes as standard with the SMART remote control unit.
®
Value
1 ~ 220-240 V AC
50/60 Hz
IP54
6 A
2 x 6 A
Value
85% maxi. (no condensation)
-10°C to +70°C
Connector
PE N, L, 1, 2, 3
33 25
8 8
It is imperative to
respect the colours
of the cables
when making the
connections so
as not to cause a
malfunction.