Tabla de contenido
Publicidad
3
6
5
7
8
6
Figure 3
Page 18
2
1
5
4
Figure 2
2
4
9
HOW TO CLEAN AN AREA OF CARPET
CAUTION:
The recovery tank is equipped with an
electric shut-off float switch. When the
recovery tank becomes full, all electrical
functions will automatically be shut off.
Turn the vacuum/accessory and spray/
brush switch to the "OFF" position
before emptying the recovery tank.
Recomendations for best Wash-n-Rinse cleaning results
1. Vacuum carpet thoroughly before cleaning.
2. Precondition spots, stains and any high traffic areas as
needed.
3. Clean carpet by following the instructions in this section.
See "How to Operate the Machine".
4. After cleaning, dry carpets by using Clarke fans. Windows
should be open to assist in proper drying.
Note: When using the extractor to clean carpets, follow this
procedure:
1. Do not walk on freshly cleaned carpets for at least four hours
or until the carpet is dry to touch.
2. If aluminum or plastic pieces have been placed under the
legs of furniture, do not remove them until the carpet is dry.
3. Do not allow children or pets to crawl or walk around on the
damp carpet.
4. Vacuum right after the carpet is dry and then vacuum the
carpet once a week, or as often as needed.
To clean an area of carpet, follow this procedure: (See
figure 2)
1.
Put water into rinse tank and cleaning solution into the
chemical tank. Clarke recommends using Clarkare
Extractor Concentrate as a cleaning solution.
2.
Turn the vacuum/accessory/switch to the "I" position.
3.
To adjust brush height, place brush adjusting rod in the
position that corresponds to your carpet type. Proper
adjustment is with approximatley 1/8" bristle engage-
ment. NOTE: Incorrect brush height may cause circuit
breaker to trip. Raise brush and reset circuit breaker.
4.
Turn the spray/brush switch to the "I" position (or for
intermittent use, press and hold the spray/brush switch
to the "II" position). With the switch activated, slowly
and steadily pull the machine backwards.
5.
Shut the spray/brush "O" and vacuum an additional six
inches.
6.
To clean a small area of carpet, clean the carpet in
sections three feet square. As you make additional
passes, overlap one inch of the area already cleaned.
7.
To remove more liquid from the carpet, lift up slightly on
the handle, transferring machine weight to the pick up
head. The speed you move the machine will depend on
how dirty the carpet is. If the carpet is very dirty, move
the machine slower.
8.
As the machine is used, dirty solution will begin to fill the
recovery tank. When the solution tank is empty, the
recovery tank must be emptied. If the solution in the
recovery tank is foamy, the recovery tank may need to
be emptied before the solution tank is refilled.
Clarke
®
Image 20 120V Operator's Manual
Publicidad
Tabla de contenido
