Machine Controls And Features; How To Prepare The Machine For Operation - Clarke Focus II Disc 26 Manual De Instrucciones

ENGLISH
EN

MACHINE CONTROLS AND FEATURES

Squeegee Lift Handle (Manual Squeegee Lift) (See figure 2)
The squeegee lift handle is located below the control handles in
the center. It is used to raise or lower the squeegee.
Float Shut Off (See Figure 3).
The shut-off switch for the vac motor is located in the recovery
tank. It automatically turns off the vac motor when the recovery
tank is full.
HOW TO PREPARE THE MACHINE
FOR OPERATION
How To Install The Batteries
This machine uses four - 6 volt batteries. The batteries are
located in the battery compartment under the recovery tank.
To install the batteries, follow this procedure:
1. Turn machine off. Set brake (if equipped).
2. Make sure recovery tank is empty.
3. Tip up the recovery tank to it's full open position. See
figure 4.
CAUTION: Before raising the tank, be sure
tank is empty.
WARNING: Do not operate the machine while the
recovery tank is in the open position. The
tank can be accidentally bumped and it may
slam shut.
4. Place the batteries in the tray as shown in
figure 5.
WARNING: The batteries are heavy. Lifting batteries
without help could result in an injury. Get
help to lift the batteries.
WARNING: Working with batteries can be dangerous.
Always wear eye protection and protective
clothing when working near batteries. NO
SMOKING!
5. Connect the cables between batteries and install battery
cable assembly as indicated. See figure 5.
6. Join the connector from the battery pack to the connector on
the control panel.
7. Close recovery tank by slowly lowering the tank.
WARNING: Never charge a GEL battery with an
unsuitable battery charger. Carefully
follow the instructions by the manufacturer
of the batteries and battery charger.
-10-
®
Clarke
Operator's Manual (EN) - FOCUS II MID-SIZE AUTOSCRUBBER
Figure 2
Figure 3
Figure 4
FRONT
Figure 5
®