How To Empty The Recovery Tank; How To Empty The Solution Tank - Clarke IMAGE 20 I Libro De Instrucciones

Page 20
HOW TO CLEAN AN AREA OF CARPET (cont.)
How To Clean A Larger Area Of Carpet
See figure 3.
To clean a larger area of carpet, follow this procedure:
1. Begin at the right-hand corner of the carpet.
2. Make a pass halfway along the edge of the carpet.
Pull the machine backward at a steady speed.
3. Move to the edge of the carpet. Make another pass
next to your first pass.
4. As you make more passes, overlap one inch of the
area already cleaned. Make each pass four inches
different in length to prevent making a line in the
center of the carpet.
5. Make more passes until half of the carpet is
cleaned.
6. Move to the right hand corner of the carpet not yet
cleaned.
7. Make a pass halfway along the edge of the carpet.
8. As you make passes, overlap one inch of the area
already cleaned.
9. Make more passes until all of the room is cleaned.
CAUTION: Clarke will not be held liable for dam-
age to the carpet, or poor results be-
cause of the operator's lack of ability.
OPERATOR'S MAINTENANCE

How to Empty the Recovery Tank

To empty the recovery tank, follow this procedure:
1. Turn all switches on the machine to the "O" position.
2. Position the machine over a drain or position a bucket
under the drain valve spout.
3. Turn the valve.
4. Close the drain valve.
CAUTION: The recovery tank is equipped with
an electric shut-off float switch. When
the recovery tank becomes full, all
electrical functions will automatically
be shut off. Turn the vacuum/acces-
sory and spray/brush switches to the
off position before emptying the re-
covery tank.

How to Empty the Solution Tank

1. Turn all switches on the machine to the "O" position.
2. Position the machine over a drain or position a bucket
under the drain valve spout.
Clarke ® Image 20 120V Operator's Manual