Riving knife
16
Sawdust removal connector
17
Adapter for vacuum sawdust removal
18
Cutting depth scale
19
Auxiliary handle
20
Drive spindle
21
Mounting flange
22
Clamping flange
23
Clamping screw with plain washer
24
Riving knife mounting
25
26
Mounting screws
©
Included items
1 Circular saw
2 Batteries 1,5 V, LR 44 (Laser)
1 Guide fence
1 Adapter for vacuum sawdust removal
1 Allen key
1 Operating instructions
©
Technical information
Rated power:
Rated voltage:
No-load rotational speed: n
Saw blade:
Cutting depth:
Protection class:
Noise and vibration data:
Measured values for noise are determined in ac-
cordance with EN 60745. The A-weighted noise
level of the electrical power tool are typically:
Sound pressure level:
Sound power level:
Uncertainty K:
Wear ear protection!
Evaluated acceleration, typical:
Hand / arm vibration a
h
Uncertainty K = 1.5 m / s
Introduction / General safety advice for electrical power tools
1300 W
230 V∼, 50 Hz
2200 – 5200 min
0
190 x 30 x 1.8
(2.6 mm tooth thickness)
66 mm
96 dB(A)
107 dB(A)
3 dB
2
= 3.447 m / s
2
instructions has been measured in accordance with
a standardised measurement procedure specified in
EN 60745 and can be used to compare devices.
Different uses of the device give rise to different vi-
bration levels and in many cases they may exceed the
values given in these instructions. It is easy to under-
estimate the vibration load if the electrical power
tool is used regularly in particular circumstances.
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particular
period of working, you should also take into account
the intervening periods of time when the device is
switched off or is running but is not actually in use.
This can result in a much lower vibration load over
the whole of the period of working.
General safety advice for
electrical power tools
and instructions! Failure to observe the safety
advice and instructions may result in electric shock,
fire and / or serious injury.
-1
Keep all the safety advice and instructions
in a safe place for future reference!
The term "electrical tool" used in the safety advice
refers to electrical tools powered by mains electrici-
ty (by means of a mains lead) and electrical tools
powered by rechargeable batteries (without a
mains lead).
1. Workplace safety
a) Keep your working area clean and
well lit. Untidy or poorly lit working areas
can lead to accidents.
b)
Do not work with the device
in potentially explosive envi-
ronments in which there are
inflammable liquids, gases or dusts.
Electrical power tools create sparks, which can
ignite dusts or fumes.
The vibration level given in these
Read all the safety advice
GB/MT
49