Connecting The Vacuum Sawdust Extraction Device; Changing A Saw Blade; Installing And Setting The Riving Knife; Tips And Tricks - Parkside PHKS 1300 A1 Instrucciones De Utilización Y De Seguridad

Preparing for use
Make sure that the cutting speed resulting from the
effects of different saw blades, materials and the
force you apply to advance the saw is always less
than the circumferential speed (CS) under no load.
©
Connecting the vacuum
sawdust extraction device
Insert the adapter for vacuum sawdust removal
18 into the sawdust removal connector
Connect a vacuum device approved for the
extraction of sawdust and splinters (see Fig. A).
©

Changing a saw blade

Press the spindle lock only after
the mains plug has been pulled out of the socket!
1. Then remove the guide fence
the wing screw
13
2. Set the cutting depth (by means of the wing
screw for cutting depth setting clamp
the minimum position, 0 mm.
3. Swing back the retractable blade guard
with the help of the retracting lever
the device down.
4. Press the spindle lock button
and release the clamping screw
Allen key 6 . Now remove the clamping screw
with integral washer head
ing flange (see Fig. D).
23
5. Detach the saw blade.
6. The installation of a sawblade is done in the
reverse order.
7. Press the spindle lock button
and tighten the clamping screw
Allen key.
The arrow on the saw blade
must agree with the arrow showing the direction of
rotation (running direction shown on the device).
Ensure that the saw blade is suitable for the
saw spindle speed.
56 GB/MT
17
by releasing
15
.
) to
5
7
and put
7 a
4 (until it engages)
24 using the
24 and the clamp-
(until it engages)
4
using the
24
©
Installing and setting
the riving knife
knife and the saw blade must not be greater
16
than 5 mm. If the riving knife has been removed e.g.
for a plunge cut, this distance must be observed
again when the riving knife is reinstalled (see Fig. F).
Removing the riving knife (see Fig. E):
. 1. Release the wing screws of the cutting depth
setting clamp
up until it meets the stop; this exposes the riving
knife mounting
2. Screw out the mounting screws
the riving knife
cut the riving knife
the circular saw is used for any other sawing tasks.
Setting the riving knife (see Fig. F):
Set the distance between the riving knife
the tips of the saw blade teeth to a maximum of
5 mm, and the distance between the tip of the riving
blade and the lowest point of the saw blade to a
maximum of 5 mm.
The distances to be set are illustrated in Fig. F.
©

Tips and tricks

Use the cutting angle scale according to the
cutting angle
45° cut = 45° mark.
Breaking out of the cut edges of delicate sur-
faces, e.g. coated chipboard or doors, can be
avoided by applying masking tape in advance
along the cutting line. This has the additional
advantage that masking tape shows up the cut-
ting line better than a smooth surface. An even
more effective way of stopping the cut edges
from being broken out is to clamp a thin piece
of wood along the cutting line, which is then
also sawn through.
The distance between the riving
5 and swing the circular saw
25 .
and remove
26
.
16
After completion of the plunge
must be reinstalled before
16
16
: rectangular cut = 0° mark,
12 b
and