Forced Vcr1 Input Setting - Pioneer AVD-W6010 Manual Del Usuario

Operating the Setup Menu

Forced VCR1 Input Setting

This product features a function that automatically switches to the video input into the
VCR1 jack when a back-up camera is installed on your car. If this is the case, when the
gear shift is in the REVERSE (R) position, the video automatically switches to VCR1.
(The initial setting is [BATTERY]. For more details, consult with your dealer.)
1. Display a menu screen and select [CONTROL SETTING] menu.
(Refer to page 14.)
2. Select an appropriate setting for the connection method.
[BATTERY]: When the gear shift is moved to the REVERSE (R) position, and the polari-
[GND]: When the gear shift is moved to the REVERSE (R) position, and the polarity of
the connected lead wire (refer to page 29) is negative.
Note:
• Switching to the correct video setting may not occur. Confirm that directly after changing the set-
ting, it changes to VCR1 when the gear shift is moved to REVERSE from another position.
• When the display changes to VCR1 video during normal drivings, reverse the settings.
CAUTION
This function is designed for use with a back-up camera only. Users may
connect the VTR 1 input with "AUTOMATIC INPUT SWITCHING" only
to such a back-up camera. Users must not connect any other devices to the
VTR 1 input with "AUTOMATIC INPUT SWITCHING".
19
ty of the connected lead wire (refer to page 29) is positive.
C O N T R O L S E T T I N G
FORCED VCR1
POLARITY BATTERY
S E L E C T