Changing Wheel Bearing - SHERCO ST Serie Manual De Taller

- Loosen axle block nut
- Loosen and remove front axle
- Release the wheel The bearings are
mounted on either side of the bushing.
When changing the bearings, note the
separator sleeve mounted between
them.
- Loosen the rear axle and remove the
axle towards the left.
- As with the front wheel, the bearings go
on either side of the bushing with the
inner separator between them. Bear in
mind the separator that goes between
the bearing and the swivel when
reassembling.
- When dismantling, it is convenient to
heat the surface where the bearing
is lodged and remove it using a ø20
pushing tube. Decant the pusher
slightly on the front wheel in order to
remove the bearing.
130

CHANGING WHEEL BEARING

ST SERIES