Check Manual Transfer Switch Operation - Generac 8 kW Directries De Instalación

shutoff valves in the fuel supply lines must be
open.
During initial start up only, the generator may exceed the
normal number of start attempts and experience an
"OVERCRANK" fault. This is due to accumulated air in
the fuel system during installation. Reset the control
board by pushing the OFF button and ENTER key, and
restart up to two more times if necessary. If unit fails to
start, contact an Independent Authorized Service Dealer
for assistance.
Use UP and DOWN
Power Up Unit
arrows to select fuel
type then press
"ENTER"
FIRMWARE V 1.01
HARDWARE V 1.05
Fuel Selection
+ NG or LP -
ENTER
Cold Smart Start?
YES or NO
Note: If language was previously programmed this goes directly to "Select Hour"
Language
+ English -
Defaults to English
+ Espanol -
if not selected.
+ Francais -
+ Portuguese -
ENTER
ENTER
Select Hour (0-23)
- 14 +
*
* Holding the Up or Down arrow
button for 2 seconds will speed dial
through the selections
ENTER
Install Wizard
Set Exercise
Installation Guidelines For 60 Hz Air-cooled Generators
Install Wizard
ESC
Cold Smart Start?
- YES or NO +
ENTER
Select Min (0-59)
- 0 +
*
Select Frequency
ENTER
- WEEKLY +
- BIWEEKLY +
- MONTHLY +
Figure 7-2. Installation Wizard Menu Map
Section 7: Control Panel/Start-up/Testing
Check Manual Transfer Switch
Operation
Refer to the "Manual Transfer Operation" section of the
Owner's Manual for procedures.
Electrocution. Do not manually transfer under load.
Disconnect transfer switch from all power sources
prior to manual transfer. Failure to do so will result
in death or serious injury, and equipment damage.
ENTER
Select Month (1-12) Select Date (1-31)
- 2 +
*
ENTER
Select Hour (0-23)
- 14 +
*
ENTER
Switched to "OFF"
Hours of Protection
0 (H)
DANGER
+
UP ARROW =
-
DOWN ARROW =
ENTER
Select Year (0-99)
- 13 + - 13 +
*
ENTER
Select Min (0-59)
- 0 + - Wednesday +
*
SYSTEM DATE/TIME
BAT- SUB MENUS
(000132)
*
Select Day
*
000622
27