Rear Panel - Tripp-Lite SmartPro SMART3000RMOD2U Manual Del Propietário

Features
( continued )

Rear Panel

1
External Battery Connector: Use this connector to attach one or more Tripp Lite optional external battery packs to the power module. Remove the
retention bracket for access. Check to ensure that the external battery pack you are connecting matches the voltage listed next to the battery connector.
Refer to the battery pack owner's manual for additional connection instructions and safety warnings.
2
Serial and USB Ports: These serial (RS-232 DB9) and USB ports enable optional connection of the UPS to corresponding ports on a workstation or
server. When the UPS System is connected to a computer via the included serial or USB cable, Tripp Lite's PowerAlert Software can be used to monitor
and control the UPS System. PowerAlert can also save files and shut down computers automatically during extended power failures.
3
Battery Configuration Port (RJ-45): This port enables the UPS to automatically detect up to four external Tripp Lite battery packs and estimate the
remaining battery run time. NOTE: This port will only detect external battery packs that support this feature.
4
Accessory Slot: Remove the slot's cover to install an optional internal SNMP/Web accessory card (Model: SNMPWEBCARD) to enable remote UPS
monitoring and control via SNMP, Web or telnet. Call (773) 869-1234 or go to www.tripplite.com to learn about available SNMP, network management
and connectivity products. The accessory slot also accepts Tripp Lite's Relay I/O Card (Model: RELAYIOCARD).
5
5 AC Output Receptacles (Outlets): These six NEMA 5-15R outlets accept NEMA 5-15P plugs (four outlets for Load 1 and two outlets for Load 2).
5A
This NEMA L5-30R outlet accepts a NEMA L5-30P plug (Load 3).
6
AC Output Breakers: These breakers prevent the AC output receptacles from operating when they are overloaded.
7
Ground Screw: Provides optional grounding for the UPS.
8
EPO (Emergency Power Off) Port (RJ-11): This port enables optional connection to a facility's Emergency Power Off circuit for emergency shutdown
of the UPS inverter. (See "Optional Installation" section for more information.) CAUTION! Do not connect a telephone line to this port.
NOTE: For additional information, see "Optional Installation" section.
1
2
3
8
201112106 93-2729.indb 4
4 5
7
4
6 5A
12/28/2011 3:44:02 PM