Fig. 8:
Attaching straps
4. Use a block and tackle of sufficient strength to lift
the FALCO EVO 622/622 IT and erect it at the inten-
ded location. Pay attention to the minimum distan-
ces as shown in the illustration.
Fig. 9:
Attaching straps
Sicam srl società unipersonale
Commissioning | FALCO EVO 622/622 IT | 39
WARNING – Danger of tipping if the lifting
straps are not attached properly
The center of gravity of the
FALCO EVO 622/622 IT is not in the middle.
¶
Always lift the FALCO EVO 622/622 IT slowly.
Fig. 10:
Erection clearance
!
For safe and ergonomic operation of the
FALCO EVO 622/622 IT, it is essential to set up the
FALCO EVO 622/622 IT at a minimum distance of
500 mm from the nearest wall. When doing so,
remember to allow for the maximum space require-
ment when extending the moving parts into opera-
ting position.
i
Rubber vibration dampers (A) are fitted at the res-
ting points to ensure low-vibration mounting on the
floor.
Fig. 11:
Vibration dampers
A Vibration dampers
5. Remove the lifting straps from the
FALCO EVO 622/622 IT.
6. Fill the lubricant tank with commercially available
tire fitting lubricant.
en
|
1 695 101 508
2014-03-21