Operating The Air Conditioner Without The Remote Control; Restarting The Air Conditioner Automatically - Friedrich MW24Y3J Manual Del Proprietário

OPERATING INSTRUCTIONS
22
Operating the air conditioner
without the remote control
You can use the On/Off button of the indoor
unit to operate the air conditioner when the
remote control is unavailable. However, the
fan speed is set to high.
1
Open the front cover.
- Lift up both sides of the cover slightly.
* Features may change according to the
type of model.
2
Press the On/Off button.
* Features may change according to the
type of model.
- For cooling and heating models, the oper-
ation mode changes based on the room
temperature as indicated in the table
below.
Room temp.
Below 70°F (21°C)
Above 70°F (21°C)
and below 75°F
(24°C)
Above 75°F (24°C)
- Cooling-only models are set to 72°F
(22°C).
ON/OFF
button
Set Operation
temp. mode
75°F Heating
(24°C) operation
73°F Dehumidifying
(23°C) operation
72°F Cooling
(22°C) operation
Restarting the air conditioner
automatically
When the air conditioner is turned on again
after a power failure, this function restores
the previous settings. This function is a facto-
ry default setting.
Disabling auto restart
1
Open the front cover.
- Lift up both sides of the cover slightly.
* Features may change according to the
type of model.
2
Press the On/Off button and hold it for 6
seconds.
- The unit will beep twice and the lamp
will blink twice 4 times.
* Features may change according to the
type of model.
- To re-enable the function, press the On/
Off button and hold it for 6 seconds. The
unit will beep twice and the lamp will
blink 4 times.
NOTE
!
If you press and hold the On/Off button
for 3 – 5 seconds instead of 6 seconds,
the unit will switch to the test operation.
In the test operation, the unit blows out
strong air for cooling for 18 minutes and
then returns to the factory default set-
tings.
ON/OFF
button