Assembly; Removing From Carton; Loose Parts - Craftsman 247.88190 Manual De Instrucciones

1
NOTE: References to right or left side of the snow thrower are
determined from behind the unit in the operating position (standing
directly behind the snow thrower, facing the handle panel).

Removing From Carton

1. Cut the corners of the carton and lay the sides flat on the ground.
Remove and discard all packing inserts.
2. Move the snow thrower out of the carton.
3. Make certain the carton has been completely emptied before
discarding it.

Loose Parts

Two replacement auger shear pins are included with this manual.
Refer to Augers on page 15 for more information regarding shear pin
replacement.
Setting up Snow Thrower
1. Observe the lower rear area of the snow thrower to be sure both
cables are aligned with roller guides before pivoting the handle
upward.
2. Secure the handle by tightening the plastic wing knob located on
both the left and right sides of the handle. Remove and discard any
rubber bands, if present. They are for packaging purposes only.
3. Position the chute assembly over the base.
4. Close the flange keepers to secure the chute assembly to the chute
base. The flange keepers will click into place when properly secure.
NOTE: If the flange keepers will not easily click into place, use the
palm of your hand to apply swift, firm pressure to the back of each.

ASSEMBLY

2
3
4