Aiwa Z-HT63 Manual Del Usuario página 24

1 Press the VIDEO/AUX and start playback of the
video source.
2 Press DOLBY PRO LOGIC.
NORMAL is selected, and the playback sound has the DOLBY
PRO LOGIC effect.
To
cancel DOLBY PRO LOGIC mode
Press DOLBY PRO LOGIC repeatedly until "PRO-OFF" is
displayed.
To change the sound levels during playback
After adjusting the balance with the noise sequencer, the sound
levels of the center or surround speakers can be adjusted during
playback of laser discs or video software.
1
2
Press MANUAL SELECT on the remote control repeatedly
to select "CEN" (center), "S-R" (surround right) or "S-L"
(surround left).
While the "CEN", "S-R" or "S-L" is displayed, press - or
> on the remote control to adjust the volume.
!s!!Tw*. &
,,!. - .,
*P . . ;.-,, ,, *,g.,
r,.
! -3 . "i,.ws'-wr ,-..,
" .:. i ,.- ,<..
sq:.
"%.=-,
* P.-B
r-.x B3- Ww?-a H.-w ;,+-
!8,
,-..."., %
ADDITIONAL DOLBY PRO LOGIC MODES
In addition to the NORMAL mode, this unit is also equipped with
the PHANTOM and the 3 STEREO modes.
PHANTOM mode: Use this mode when no center speaker is
connected. The center channel signals are output through the
left and right speakers.
3 STEREO mode: Use this mode when no surround speakers
are connected. This mode reproduces rear sounds through the
front speakers.
To select
PHANTOM or
3
STEREO
Press DOLBY PRO LOGIC repeatedly until the desired DOLBY
PRO LOGIC mode is displayed. The DOLBY PRO LOGIC mode
is displayed cyclically as follows.
Cp:g,"a
(cancel)
To adjust the balance of connected speaker sound levels
Carry out steps 2 to 4 on page 23.
Depending on the sound source and/or listening conditions,
surround effect may not be obtained even when the DOLBY
PRO LOGIC is on.
The full DOLBY PRO LOGIC effect cannot be obtained when
using software without UUI-SLIMWNDI mark. In this case, use
the DSP SURROUND system instead (see page 11).
The DOLBY PRO LOGIC is automatically canceled when:
- the ECHO is turned on.
- the DSP SURROUND system or the BBE is turned on.
- the headphones are plugged in.
- the Karaoke function is turned on.
- the 5.1 CH (page 31) is turned on.
Set the microphone volume to OFF while the DOLBY PRO
LOGIC is on. Otherwise, the DOLBY PRO LOGIC sound cannot
be reproduced correctly.
24
ENGLISH