Aiwa Z-HT63 Manual Del Usuario página 25

K:-
'
'-"
':-2'1
.i. _
Two microphones (not supplied) can be connected to this unit,
allowing you to sing along to music sources.
Use microphones with standard plugs (06.S mm,
'/4
inch).
Before connecting a microphone
Press MIC and turn VOLUME counterclockwise until "MIC OFF"
is displayed.
Connect your microphones to MIC 1 and MIC 2
jacks.
1–MIC-2
Press one of the function buttons to sellect the
source to be mixed, and play the source.
Adjust the volume and tone of the source.
Press MIC and turn VOLUME @bin 4 seconds to
adjust the microphone volume.
The microphone volume can be selected from 1 to MAX (7)
or OFF (cancel).
The volume of both microphones is adjusted simultaneously.
Press ECHO and turn VOLUME within 4 seconds
to adjust the echo level.
The echo level can be selected from 1 to MAX (7) or OFF
(cancel).
To change the delay time of echo
g
Hold down ECHO while the echo is on. "ECHO-~ (Long) and w
"ECHO-M" (Middle) are displayed alternately. At the desired 'u
position, release the button.
':':
- ,i
To record microphone sound mixed with source sound ~ ~~
Follow the procedure for recording from the sound source (see ~ ~
page 19).
1
SYNC DUB cannot be used for mixing recording.
g
When
the
microphones are not in use
Set the microphone volume and echo level to OFF and remove
the microphones from MIC jacks.
i'
,s:,
m
"~,
MIC and ECHO are reset to OFF automatically when the ,EI,
function is changed, the DOILBY PRO LOGIC or one of the '*
DSP mode buttons is pressed, the power is turned off, or the
*
AC cord is disconnected.
If the MIC or ECHO is turned on while the 5.1 CH (page 31) is
selected, the 5.1 CH is changed to the VIDEO.
When the ECHO level is changed, the DSP SURROUND
system and the DOLBY PRO LOGIC are automatically
canceled.
When the headphones are connected, the DSP SURROUND
system and the DOLBY PRO LOGIC are automatically
canceled.
If a microphone is held too
neiar'
the speakers, a howling sound
may be produced. In this case, hold the microphone away from
the speakers, or decrease the microphone volume.
If sound through the microphone is extremely loud, it may be
distorted. In this case, decrease the microphone volume.
Recommended microphones
Use of unidirectional type microphones is recommended to
prevent howling. Contact your local Aiwa dealer for details.
ENGLISH
25