Aiwa Z-HT63 Manual Del Usuario página 28

CLOCK ANO TIIMER
When the clock is set, the 1':"between the hours and minutes
flashes. VJhen the power cord is plugged into an AC outlet for
the firs~time after purchase or when the clock setting is canceled
due to a power failure, the entire clock display flashes.
1
2
3
Press CLOCK,,
Within 4 seconds, turn MULTI JOG to designate
the hour and the minute.
Turning MIJLTI JOG changes both the hour and the minute.
*I or - is also available instead of MULTI JOG. Holding
these buttons down will vary the time rapidly.
Press ENTER or 11.
The clock starts from 00 seconds.
To view ihe clock when another display is in the display
Press CLOCK. The time is displayed for 4 seconds and then the
original display reappears. However, the clock cannot be
displayed during recording.
To switch to the 24-hour standard
Press CLOCK and then press within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
If the display flashes when the clock is displayed, it indicates
that the clock has stopped due to a power failure or the
removal of the power cord. The current time needs to be reset.
The Iunit can be turned off automatically at a specified time,
Use 'the remote control.
1
2
Press SLEEP on the remote control.
Within 4 seconds, turn MULTI JOG
or
press
olr -
to specify the time until thle power is
turned off.
The time changes between 5 and 240 minut,ss in 5-minute
StBPS.
Specified time
To check the time remaining until the powet' turns off
Press SLEEP once. The rem-aining time- is displayed for
seconds.
To cancel the sleep timer
Press SLEEP twice so that "SLEEPoFF" appears.
4
If the power-economizing mode (page 7) is on, all the display
lights turn off when the power is turned off. To view the clock,
press CLOCK so that the time is displayed for 4 seconds.
28
ENGLISH