Closing The Netdirector Console Kvm; Lcd Osd (On-Screen Display) Configuration - Tripp-Lite B020-008-17 El Manual Del Propietario

5. Basic operation

5.2 Closing the NetDirector Console KVM

To slide the console module back in, close the cover and do
the following:
1. Pull the safety catches on the unit's side rails toward you
and push the module in until it stops.
2. Release the catches; pull the module slightly toward you;
then push it all the way in.
Note: The reason for the two-step procedure is to minimize the chances of
pinching your fingers when sliding the module in.

5.3 LCD oSD (on-Screen Display) Configuration

The LCD oSD allows you to set up and
configure the LCD display:
• To open up the LCD OSD main menu, press the
button marked Menu.
• Use the | and
adjustments. After navigating to a setting choice, use
the Menu button to bring up the adjustment screen.
• When making adjustments,
| decreases the value.
• When satisfied, press
menu.
• When all adjustments have been made, press
close the LCD OSD.
The following is an explanation of the settings:
Auto Adjust Automatically configures all the settings for the LCD panel to the levels the OSD
considers optimal.
Brightness Adjusts the background black level of the screen image.
Contrast Adjusts the foreground white level of the screen image.
Phase Adjusts the vertical size of the screen image.
Clock Adjusts the horizontal size of the screen image.
H-Position Positions the display area on the LCD panel horizontally (moves the display area left
or right).
V-Position Positions the display area on the LCD panel vertically (moves the display area up or
down).
Color Adjusts the color quality of the display. You can adjust the "warmth" value, color
Adjustment balance, etc. Has a further submenu to allow the fine-tuning of the RGB values.
Language Selects the language that the OSD displays its menus in (English, French, Spanish,
German, Italian).
Recall Returns the adjustments on all menus and submenus to their factory default settings.
( Continued )
| buttons to navigate and make
| increases the value;
Exit to return to the OSD main
Exit
m
Exit to
11
| | Menu
m m m