Hotkey Beeper Control; Hotkey Summary Table - Tripp-Lite B020-008-17 El Manual Del Propietario

6. Hotkeys

6.11 Hotkey Beeper Control

The Beeper can be turned On/Off via Hotkey or the OSD (see pages 16-21 for OSD details).
To toggle the Beeper, key in the following Hotkey combination:
1) Invoke Hotkey Mode with the
[B]
2) Key in
After you press [B], the Beeper toggles On or Off. The Command Line displays Beeper On or
Beeper Off for one second; then the message disappears and you automatically exit Hotkey Mode.

6.12 Hotkey Summary Table

Hotkey Sequence – Starting with [Num Lock] + [-] or [Num Lock] + [*] then ...
[Port ID] [enter]
[T] [n] [enter]
[A]
[]
[]
[]
[]
[B]
† Once Skip Mode has been invoked and until you exit, you can keep on skipping simply by pressing an Arrow key. You don't have to use
the [Num Lock] + [-] combination again.
( Continued )
[Num Lock] + [-] combination
Switches access to the computer connected to that Port ID.
Sets the Auto Scan interval to n seconds - where n is a number from 1 - 255.
Invokes Auto Scan Mode.
Invokes Skip Mode and skips from the current port to the first accessible port
previous to it. †
Invokes Skip Mode and skips from the current port to the next accessible port.
Invokes Skip Mode and skips from the current port to the last accessible port of
the previous Station. †
Invokes Skip Mode and skips from the current port to the first accessible port of
the next Station. †
Toggles the Beeper On or Off.
15
†