Starting Auto Scan; Pausing In Auto Scan; Skip Mode - Tripp-Lite B020-008-17 El Manual Del Propietario

6. Hotkeys

6.8 Starting Auto Scan

To start Auto Scanning, enter the following Hotkey combination:
1) Invoke Hotkey Mode with the
[A]. After you press A, you automatically exit Hotkey Mode and enter Auto Scan Mode.
2) Key in
3) An autoscan can be paused at any time (see below).
4) To exit Auto Scan Mode, press
Note: While Auto Scan Mode is in effect, ordinary keyboard and mouse functions are suspended - only Auto Scan Mode compliant
keystrokes and mouse clicks can be input. You must exit Auto Scan Mode in order to regain normal control of the console.

6.9 Pausing in Auto Scan

While in Auto Scan Mode, the scan can be paused in order to keep the focus on a particular computer
either by pressing P or with a left click of the mouse. During the time that Auto Scanning is paused, the
Command Line displays: Auto Scan: Paused.
In many cases Pausing is more convenient than Exiting the Auto Scan Mode because when you Resume
scanning while in Pause, you start from where you left off. If you Exited and restarted, scanning would
start from the very first computer on the installation.
To resume Auto Scanning, press any key or left click. Scanning continues from where it left off.

6.10 Skip Mode

This feature allows you to manually sequence between computers in order to monitor them. This manual
version of the Auto Scan mode lets you dwell on a particular port for as long as you like. To invoke
Previous/Next Switching, key in the following Hotkey combination:
1) Invoke Hotkey Mode with the [
Arrow] refers to any of the arrow keys on the keyboard. After you press [Arrow], you
2) Key in [
automatically exit Hotkey Mode, and enter Skip Mode where you can switch ports as follows:
Skips from the current port to the first accessible port previous to it. (See Scan/Skip Mode,
page 17, or information regarding accessible ports.)
Skips from the current port to the next accessible port.
Skips from the current port to the last accessible port of the previous Station.
Skips from the current port to the first accessible port of the next Station.
3) To exit Skip Mode, press
Note: 1. Once Skip Mode has been invoked, until you exit, you can keep on skipping simply by pressing an Arrow key. You don't
have to use the [NumLock] + [-] combination again.
2. While Skip Mode is in effect, ordinary keyboard and mouse functions are suspended—only Skip Mode compliant keystrokes
can be input. You must exit Skip Mode in order to regain normal control of the console.
( Continued )
[Num Lock] + [-] combination
[Esc] or [Spacebar].
Num Lock] + [-] combination
[Esc]
14