Rackmounting For B022; Single-Station Installation; Multiple Station (Daisy-Chained) Installation - Tripp-Lite B020-008-17 El Manual Del Propietario

4. Installation

4.3 Rackmounting for B022-016

Fasten the rackmount brackets to
the rack using user-supplied
screws to install in a rack.

4.4 Single-Station Installation

1. Ensure that power to all the devices to be connected has been turned
off.
2. On a B022-016 KVM, connect the Keyboard, Mouse and Monitor
cables to the console ports on the KVM.*
3. Use the correct Tripp Lite KVM cable kits (as described in the
section on page 4), to connect a computer's Keyboard, Video and
Mouse ports to any available port on the KVM switch.
4. Plug the power cord or power adapter cable into the KVM's power jack, then plug into a UPS, surge or other AC
power source.
5. Turn on the power to the computers.
*NetDirector Console KVM Switches only need to perform this step if they are connecting to an external console.

4.5 Multiple Station (Daisy-Chained) Installation

To control even more computers, up to 31 B022-016 KVM
Switches can be daisy-chained down from the First Station.
Note: As many as 512 computers can be controlled from the unit's integrated console in
a complete installation.
To set up a daisy-chained installation:
1. Ensure that power to all the devices to be connected has been
turned off.
2. Use a daisy-chain cable (described in the
page 4) to connect the Chain Out port of the parent unit to the
Chain In port of the B022-016 child unit.
3. Use a KVM cable kit (described in the
to connect the Keyboard, Video and Mouse ports of a
computer to any available port on the KVM switch.
4. Repeat the above steps for any additional B022-016 KVM
Switches you wish to add to the chain.
5. Power up the installation according to the following procedure:
a. Plug in the power adapter for the First Station. Wait a few
seconds to allow the unit to determine its Station ID.
b. Plug in the power adapters for each subsequent Station in
the installation in turn (ie. Second Station, then Third
Station, etc.). Each B022-016 KVM Switch has an LED
display on its front panel to indicate its Station ID (the
Station ID for the First Station is 01, the ID for the Second
Station is 02, the ID for the Third Station is 03, etc.).
In each case, wait for the Station ID to be displayed on the
Station ID LED before plugging in the next Station.
( Continued )
Cables section,
Cables section, page 4)
Insert screws to connect to rack
Cables
B020-016-17 (rear)
B022-016 (rear)
B022-016 ( rear )
9