Scanner Set Up; Check The Box Contents; Install The Software - HP Scanjet N6310 Guía De Inicio

1

Scanner set up

Follow these steps to set up the scanner.

Check the box contents

Unpack the scanner hardware. Be sure to remove any shipping tape, and, if present,
remove the paper protector from the scanner glass.
NOTE: The contents of the box, including the number of scanning software CDs,
can vary by country/region.
1
1
2
3
4
5

Install the software

CAUTION: If you are installing the software on a Windows computer, do not connect
the USB cable to the computer until you are prompted to do so during the software
install. If you are installing the software on a Macintosh computer, you can connect
the USB cable either before or after installing the software. See "Connect the USB
cable" on page 4.
2 HP Scanjet N6310
HP Scanjet N6310 Document Flatbed Scanner
Power supply and power cable
USB cable
Getting Started Guide (this book)
Scanning software CDs
2
3
4
5