Operation And Usage - Klarstein STEAKREAKTOR 2.0 Manual De Instrucciones

Insert grill box and the grease drip tray
For easier cleaning of the device, of the grill box can be removed. Insert the box into the grill room. Make sure
that the box does not come into contact with the heating element in order to avoid damage. The correct po-
sitioning is achieved when the latches on the underside of the grill are engaged in the appropriate recesses in
the grill room. The grill box is necessary for safe operation and must remain in the unit during use. It may be
removed only in a fully cooled state.
To remove, slightly raise the case to release the latches located at the bottom of the grill. Pull the grill insert
carefully out of the front. Contact with the heating element must be avoided to prevent damage. During the
grilling of meat products, liquid is normally released from the food. This must not enter into the interior of the
housing. Operate therefore only with the grease drip tray inserted.
Important note about the ceramic heating element:
During operation, the ceramic heating element shows a dark spot in the middle. No heating wires can be
installed at this point. However, this has no effect on the grilling result, since the radiating behavior of the
heating is diffuse and the grill surface is evenly irradiated in the middle.
Turning on the unit and setting the temperature
To turn the unit on, press the power switch on the rear panel. The regulator allows you to increase or decrease
the temperature of the heating element. The maximum temperature is 850° C. Press the dial to confirm the
set temperature.

Operation and Usage

22