Astralpool OPTIMA Serie Manual De Instalación página 3

READ THE FOLLOWING PRECAUTIONS CAREFULLY BEFORE PROCEEDING WITH PUMP INSTALLATION
CAUTION! Always disconnect the power supply before installing or carrying out maintenance on the product
CAUTION! Follow the safety procedures relative to the dosed product
H SO SULPHURIC ACID
2 4
may react with water, dry all the internal parts of the plumbing thoroughly.
Install the pump in a zone where the environment temperature does not exceed 40ºC and the relative
humidity is below 90%. The pump has an IP65 protection level.
Install the pump so that any inspection and maintenance operations are easy to carry out, then secure the
pump firmly in order to prevent excessive vibrations.
Check that the power supply available in the network is compatible with that indicated on the pump label.
If you are injecting in pressurised pipes, always make sure that the system pressure does not exceed the
maximum working pressure indicated on the dosing pump label before starting up the pump.
WARNING: Always follow the necessary safety procedures, including the use of adequate protection
for the eyes, face, hands, and clothing.
WARNING: When installing or carrying out maintenance on this equipment, always disconnect it from
the power supply.
FIXING:
The dosing pump is supplied with a wall mounting bracket and with all the accessories for a correct installation. The picture
show the correct mounting. In case of mounting on a support or surface is necessary am optional mounting bracket ( Code
36830 ) non present.
EM00136087
PRECAUTIONS
OR MAINTENANCE
All the pumps are tested with water. When dosing chemical products that
Fixing templates
rev. 1.3 2