Setting The Calendar; Displaying The Calendar/Time; Setting The Time - Alpine iDA-X200 Manual De Operación

Setting the Calendar

1
Press and hold FUNC./SETUP for at least 2
seconds to activate the SETUP selection mode.
2
Turn the Double Action encoder (iDA-X200 only)
or Rotary encoder (iDA-X300 only) to select the
GENERAL mode, and then press
1 2
BT * AUDIO * GENERAL
3
TUNER BT
*
1
* Displayed only when INT MUTE is set to OFF, and the mode is set to
other than BT AUDIO.
2
* Displayed only when an external audio processor is connected. For
details, refer to the Owner's Manual of the external audio processor.
3
* Only when HD Radio / SAT Radio receiver is connected.
3
Turn the Double Action encoder (iDA-X200 only)
or Rotary encoder (iDA-X300 only) to select
CALENDAR ADJ, and then press
4
Turn the Double Action encoder (iDA-X200 only)
or Rotary encoder (iDA-X300 only) to set year.
5
Press /ENTER.
6
Repeat steps 4 and 5 above to set month, day.
7
Press and hold for at least 2 seconds to return to
normal mode.
• Pressing during the procedure will return to the previous mode.
• If no operation is performed for 60 seconds, the unit will return to
normal mode automatically.

Setting the Time

1
Press and hold FUNC./SETUP for at least 2 seconds
to activate the SETUP selection mode.
2
Turn the Double Action encoder (iDA-X200 only)
or Rotary encoder (iDA-X300 only) to select the
GENERAL mode, and then press
1 2
BT AUDIO GENERAL
* *
3
TUNER BT
*
1
* Displayed only when INT MUTE is set to OFF, and the mode is set to
other than BT AUDIO.
2
* Displayed only when an external audio processor is connected. For
details, refer to the Owner's Manual of the external audio processor.
3
* Only when HD Radio / SAT Radio receiver is connected.
3
Turn the Double Action encoder (iDA-X200 only)
or Rotary encoder (iDA-X300 only) to select CLK
ADJ, and then press
4
Turn the Double Action encoder (iDA-X200 only)
or Rotary encoder (iDA-X300 only) to set hour.
5
Press /ENTER.
6
Repeat steps 4 and 5 above to set minutes.
7
Press and hold for at least 2 seconds to return to
normal mode.
8
-EN
/ENTER.
DISPLAY IPOD
/ENTER.
/ENTER.
DISPLAY IPOD
/ENTER.
• Pressing during the procedure will return to the previous mode.
• If no operation is performed for 60 seconds, the unit will return to
normal mode automatically.

Displaying the Calendar/Time

Press VIEW.
The calendar/time is displayed. Pressing VIEW again will return
to normal mode.
0 7 / 1 2 / 3 1
• If an HD Radio Tuner is connected, text information can be
displayed. Refer to "Changing the Display (HD Radio mode only)"
(page 10).
• If an XM receiver is connected, the Auxiliary Data Field can be
displayed. Refer to "Setting the Auxiliary Data Field Display (XM
only)" (page 30).
Controllable With Remote Control
Point the optional remote control transmitter at the remote
control sensor.
Connectable to Steering Remote Control Interface Box
(iDA-X200 only)
You can operate this unit from the vehicle's control unit
when an Alpine Steering Remote Control Interface Box
(optional) is connected. For details, contact your Alpine
dealer.
12:00
Remote control sensor